Brad
06-18-2003, 02:27 PM
I made a few pulls last Saturday, ill post the sheet later, but here is what happened. At 5000RPM I made my max power of 460RWHP and 510 pound feet of torque. On that pull all I was doing was watching the boost gauge, at about 4800 RPM I went from 15 pounds of boost to about 10. Clearly there is some belt slip! Is that why I made my max power at 5000RPM? My power line climbs right to 5000 then just plains out then falls into the low 400’s at 6500, at that point the line gets real choppy.
Power Mods
2.80
steeda CAI
magnaflow cat back
magnaflow X
Diablo delta
I think I might need plugs, and I think I need to install a metco idler, do you guys think that will make the difference? Assuming I can make the boost stick to redline what do you think my power will be??
The good news is at WOT my A/F looks like this right to 6500
12.5 -------------------------------------------------------------
Power Mods
2.80
steeda CAI
magnaflow cat back
magnaflow X
Diablo delta
I think I might need plugs, and I think I need to install a metco idler, do you guys think that will make the difference? Assuming I can make the boost stick to redline what do you think my power will be??
The good news is at WOT my A/F looks like this right to 6500
12.5 -------------------------------------------------------------